If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
WTB: King Concepts Enterprise Parts
Looking for solenoid valves and thermistors for King Concepts
Enterprise processor. |
#2
|
|||
|
|||
Hi
have you had any help yet on finding the parts ?? I am looking for parts too I need the peter paul electronics solenoid valves and the float switch. I have some diaphragm {10468} for the tank valves if that wood help. 1banjo |
#3
|
|||
|
|||
On Sun, 09 May 2004 15:23:09 -0400, "1banjo"
wrote: Hi have you had any help yet on finding the parts ?? I am looking for parts too I need the peter paul electronics solenoid valves and the float switch. I have some diaphragm {10468} for the tank valves if that wood help. 1banjo I think my diaphragms are ok but one solenoid is not working and the water comes into the jacket way too hot and stays around 120 degrees fahrenheit. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Looking for Canon P RF parts | Uwe Kersten | 35mm Photo Equipment | 0 | November 6th 04 03:10 PM |
Boycott Pickle King Products | Steve Kramer | 35mm Photo Equipment | 4 | September 26th 04 10:51 AM |
Master Mason Handbook | Doug Robbins | 35mm Photo Equipment | 0 | July 15th 04 03:33 PM |