If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Question about parts for Jobo Processors
I have a Jobo CPA2 processor, which I'd like to use with Expert tanks.
However the lift is fitted with rollers for the smaller-diameter tanks, so the Expert tanks will work. In other words, I need to install wider rollers. My questions: 1. Where can you get replacement parts? I don't see them listed on the Jobo site. 2. Do I replace the rollers only or the rails-plus-rollers? Thanks for any advice. Please respond here, rather than with email. HDG |
#2
|
|||
|
|||
Question about parts for Jobo Processors
schreef in bericht ... I have a Jobo CPA2 processor, which I'd like to use with Expert tanks. However the lift is fitted with rollers for the smaller-diameter tanks, so the Expert tanks will work. In other words, I need to install wider rollers. My questions: 1. Where can you get replacement parts? I don't see them listed on the Jobo site. 2. Do I replace the rollers only or the rails-plus-rollers? Thanks for any advice. Please respond here, rather than with email. HDG Hi HDG, Go to the JOBO site to service , then contact. Hans |
#3
|
|||
|
|||
Question about parts for Jobo Processors
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Looking for Canon P RF parts | Uwe Kersten | 35mm Photo Equipment | 0 | November 6th 04 03:10 PM |
Strobe parts question | habs4x5 | Large Format Photography Equipment | 3 | September 16th 04 02:07 PM |
Master Mason Handbook | Doug Robbins | 35mm Photo Equipment | 0 | July 15th 04 03:33 PM |
Dilution Question | missblueamerican | In The Darkroom | 25 | March 14th 04 11:25 PM |
WTB Parts for 4x5 Crown Graphic | Mr. Bluto | Large Format Equipment For Sale | 1 | January 29th 04 04:23 AM |