Versalab Print washers

As a late entry to this discussion: I have an 11x14 washer. Easy to use.
WOrks well. Solid product. I do put 8x10's in their (vertically) as well.
But I use the washer only for larger quantities of prints. I find I can get
good washing even with relatively low flows of water--I think it saves money
on water if one is washing several prints at a time.

After fixing, I put the prints into a washing aid after a short soak in a
tray of warm water. Then I transfer the prints to the Versalab washer
filled with cool water (works as a big holding tray). Finally, I run the
washer with appropriate temperature of water. System seems to work well.
Highly recommend the product esp given the cost differentials of other
similar items.

Sam
"