If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
(Mostly) Ilford film question
The other day I was out shooting with a friend of mine, and, lo and behold, when it came time to put film in the camera, I discovered that I had none in my kit. (Upon my return home, I found several large bags of film sitting on my counter, right where I'd left it.) Fortunately, my friend is a believer in bringing abundant supplies of film (as am I, usually), so she was able to help me out. Alas, she usus completely different films than I do. My usual choices are T-Max 100, developed in T-Max developer, the venerable Tri-X in D-76, Delta 400, also in D-76, and Ilford Delta 3200 in Ilfotec DD-X . I don't claim to have arrived at these film/developer combinations by any scientific process, but the results seem fairly good, at least within the limits of my picture-taking ability. Here's what my friend gave me: Ilford FP4 Plus, Delta 100, HP5, and some T-Max 3200, which I exposed at 800 because that's what I tend to do with Delta 3200. I shot several roles of each for the for the day. I'd like them to come out, but it's not the end of the world if they don't. Now, my next step is processing, and I'm curious as to what folks would suggest. My friend is no help because she sends her stuff to a lab rather than doing it herself. On hand I have D-76, T-Max, Ilford DD-X and an unopened bottle of Ilfosol S, which bought by accident and have never used. I'd prefer to use up what I have on hand, but if all my choices are clearly unsuitable, I'd be willing to purchase something else. Obviously, what I ought to do is to go out and shoot test roles which I could then cut up and in several different developers, perhaps even with different dilutions, time and temperature combinations, etc. But I have neither the time nor the patience for such a detailed scientific analysis. I was hoping that perhaps I could find sage advice from somebody more energetic than myself. To reiterate, the exposed films I have a Delta 100 FP4 Plus HP 5 T-Max 3200. All were exposed at the box rating, except for the Delta, which I shot at 800. Oh, and since I'm asking, I currently use D-76 for both Delta 400 and Tri-X, largely since that's what I've used since I was kid. My results seem fairly good, so part of me doesn't want to change. However, I must admit that I prefer liquids to powders, so I was wondering if anybody knew of a liquid developer that would work well with these two films. Thanks in advance for the wisdom which I'm sure will follow. -- Pete McCutchen |
#2
|
|||
|
|||
When I am not using PMK, I would use D-76 for these films. (I have not
used PMK on T-Max 3200, but I have on the rest with good results.) Francis A. Miniter Pete McCutchen wrote: snip To reiterate, the exposed films I have a Delta 100 FP4 Plus HP 5 T-Max 3200. All were exposed at the box rating, except for the Delta, which I shot at 800. Oh, and since I'm asking, I currently use D-76 for both Delta 400 and Tri-X, largely since that's what I've used since I was kid. My results seem fairly good, so part of me doesn't want to change. However, I must admit that I prefer liquids to powders, so I was wondering if anybody knew of a liquid developer that would work well with these two films. Thanks in advance for the wisdom which I'm sure will follow. |
#3
|
|||
|
|||
When I am not using PMK, I would use D-76 for these films. (I have not
used PMK on T-Max 3200, but I have on the rest with good results.) Francis A. Miniter Pete McCutchen wrote: snip To reiterate, the exposed films I have a Delta 100 FP4 Plus HP 5 T-Max 3200. All were exposed at the box rating, except for the Delta, which I shot at 800. Oh, and since I'm asking, I currently use D-76 for both Delta 400 and Tri-X, largely since that's what I've used since I was kid. My results seem fairly good, so part of me doesn't want to change. However, I must admit that I prefer liquids to powders, so I was wondering if anybody knew of a liquid developer that would work well with these two films. Thanks in advance for the wisdom which I'm sure will follow. |
#4
|
|||
|
|||
"Pete McCutchen" wrote
Ilford FP4 Plus, Delta 100, HP5, and T-Max 3200 ... what developer D-76, same developer as Ilford's ID/11. Use mfg's times & temps. I have never seen a photo where the choice of developer either made or broke the image(with the exception of extremes - and then the photo would have been better off w/o the monkey business, IMHO). I have neither the time nor the patience for a detailed scientific analysis Same here. -- Nicholas O. Lindan, Cleveland, Ohio Consulting Engineer: Electronics; Informatics; Photonics. Remove spaces etc. to reply: n o lindan at net com dot com psst.. want to buy an f-stop timer? nolindan.com/da/fstop/ |
#5
|
|||
|
|||
May be some help with the Delta films. Don't know.
I use a simple developer made of 1 tsp. Sodium Metaborate (Kodalk), 1/2 tsp. Vitamin C powder (with or without rose hips) from the health food store, and 4 ml. of 1% Phenidone stock (1 g. Phenidone dissolved in 100 ml of 90% alcohol). The times are roughly equivalent to those for D-76 stock times which you'll find on your film info sheets--maybe 30 seconds longer. Although I usually rate my Delta at half the recommended speed, I'd suggest increasing the development a bit and try the following (either with my formula or D-76 stock.) Delta 400 --- 7 1/2 minutes at 70 degrees. Delta 100 --- 10 minutes at 70. FP4 + --- 7 1/2 at 70. This may not be perfect, but will be close enough to give you decently printable negs. Pete McCutchen wrote: The other day I was out shooting with a friend of mine, and, lo and behold, when it came time to put film in the camera, I discovered that I had none in my kit. (Upon my return home, I found several large bags of film sitting on my counter, right where I'd left it.) Fortunately, my friend is a believer in bringing abundant supplies of film (as am I, usually), so she was able to help me out. Alas, she usus completely different films than I do. My usual choices are T-Max 100, developed in T-Max developer, the venerable Tri-X in D-76, Delta 400, also in D-76, and Ilford Delta 3200 in Ilfotec DD-X . I don't claim to have arrived at these film/developer combinations by any scientific process, but the results seem fairly good, at least within the limits of my picture-taking ability. Here's what my friend gave me: Ilford FP4 Plus, Delta 100, HP5, and some T-Max 3200, which I exposed at 800 because that's what I tend to do with Delta 3200. I shot several roles of each for the for the day. I'd like them to come out, but it's not the end of the world if they don't. Now, my next step is processing, and I'm curious as to what folks would suggest. My friend is no help because she sends her stuff to a lab rather than doing it herself. On hand I have D-76, T-Max, Ilford DD-X and an unopened bottle of Ilfosol S, which bought by accident and have never used. I'd prefer to use up what I have on hand, but if all my choices are clearly unsuitable, I'd be willing to purchase something else. Obviously, what I ought to do is to go out and shoot test roles which I could then cut up and in several different developers, perhaps even with different dilutions, time and temperature combinations, etc. But I have neither the time nor the patience for such a detailed scientific analysis. I was hoping that perhaps I could find sage advice from somebody more energetic than myself. To reiterate, the exposed films I have a Delta 100 FP4 Plus HP 5 T-Max 3200. All were exposed at the box rating, except for the Delta, which I shot at 800. Oh, and since I'm asking, I currently use D-76 for both Delta 400 and Tri-X, largely since that's what I've used since I was kid. My results seem fairly good, so part of me doesn't want to change. However, I must admit that I prefer liquids to powders, so I was wondering if anybody knew of a liquid developer that would work well with these two films. Thanks in advance for the wisdom which I'm sure will follow. |
#6
|
|||
|
|||
On Fri, 29 Oct 2004 17:53:52 GMT, Pete McCutchen
wrote: Delta 100, FP4 Plus, HP 5 \/\/\/\/\/ T-Max developer 6 min. @ 70F T-Max 3200. T-Max developer 7 min. @ 70F Regards, John S. Douglas, Photographer - http://www.puresilver.org Vote "No! for the status quo. Vote 3rd party !! |
#7
|
|||
|
|||
On Fri, 29 Oct 2004 17:53:52 GMT, Pete McCutchen
wrote: Delta 100, FP4 Plus, HP 5 \/\/\/\/\/ T-Max developer 6 min. @ 70F T-Max 3200. T-Max developer 7 min. @ 70F Regards, John S. Douglas, Photographer - http://www.puresilver.org Vote "No! for the status quo. Vote 3rd party !! |
#8
|
|||
|
|||
|
#9
|
|||
|
|||
|
#10
|
|||
|
|||
I've had good luck with all those films with Ilfosol-S (It's a
one-shot, so don't re-use it.) The recommended times work fine. Jim |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Who's left in the E6 biz? | [email protected] | In The Darkroom | 49 | September 22nd 04 07:23 AM |
Question on Polaroid 35mm Film Made by Agfa | eb | Film & Labs | 2 | August 3rd 04 11:02 PM |
The first film of the Digital Revolution is here.... | Todd Bailey | Film & Labs | 0 | May 27th 04 08:12 AM |
Jobo Film loaders with base for 120 film question! | Nick Zentena | In The Darkroom | 2 | January 24th 04 10:05 PM |
A question about Efke film | JRF | Film & Labs | 4 | December 28th 03 02:42 AM |