Question about parts for Jobo Processors

I have a Jobo CPA2 processor, which I'd like to use with Expert tanks.
However the lift is fitted with rollers for the smaller-diameter
tanks, so the Expert tanks will work. In other words, I need to
install wider rollers.
My questions:
1. Where can you get replacement parts? I don't see them listed on
the Jobo site.

2. Do I replace the rollers only or the rails-plus-rollers?

Thanks for any advice. Please respond here, rather than with email.

HDG

schreef in bericht
...
I have a Jobo CPA2 processor, which I'd like to use with Expert tanks.
However the lift is fitted with rollers for the smaller-diameter
tanks, so the Expert tanks will work. In other words, I need to
install wider rollers.
My questions:
1. Where can you get replacement parts? I don't see them listed on
the Jobo site.

2. Do I replace the rollers only or the rails-plus-rollers?

Thanks for any advice. Please respond here, rather than with email.

HDG

Hi HDG,
Go to the JOBO site to service , then contact.
Hans

wrote:
I have a Jobo CPA2 processor, which I'd like to use with Expert tanks.
However the lift is fitted with rollers for the smaller-diameter
tanks, so the Expert tanks will work. In other words, I need to
install wider rollers.
My questions:
1. Where can you get replacement parts? I don't see them listed on
the Jobo site.

2. Do I replace the rollers only or the rails-plus-rollers?

There is only one type of rollers. The main difference are the holders.
You can install the rollers differently:

holders turned inwards: small tanks (15xx)
holders turned outwards: expert drums (3xxx)
holders removed, rollers installed directly: 25xx tanks

Martin