A Photography forum. PhotoBanter.com

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » PhotoBanter.com forum » Digital Photography » Digital Photography
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Is it OK to mix NiMH batteries?



 
 
Thread Tools Display Modes
  #1  
Old August 20th 08, 07:58 PM posted to rec.photo.digital
Dave Martindale
external usenet poster
 
Posts: 438
Default Is it OK to mix NiMH batteries?

" writes:
I had a set of 4 PowerEx 1800 mAH batteries from several years ago. I
threw one of them away because my charger wouldn't charge it anymore,
so now there are 3 of them left. I just bought a new charger, which
came with 2 Duracell 2000 mAH batteries. Is it OK if I take one of
the Duracell batteries and combine it with the 3 PowerEx batteries to
form a set which I can use in my camera that takes 4 batteries?


In general, no. In the best case, the capacity of the set of 4 is only
equal to the weakest of the 4 cells. But in the worst case, you will
reverse-charge the weakest cell and destroy it.

When you use 4 cells in series (which is almost certainly what a camera
that takes 4 cells does), you want all 4 to have the same capacity plus
or minus a few percent. When you use the camera, all cells deliver the
same amount of current to the load (because they're connected in
series) and all approach "empty" at about the same time. When the
weakest cell finally drops below 1 V, all the other cells are also near
1 V, the total voltage drops below 4 V, and the camera ought to shut
down *while the weak cell still has some amount of charge*.

If you have one cell whose capacity is less than the rest, it will reach
"empty" while the other cells are still at 1.2 V or above. The total
pack voltage might not drop enough for the load to detect "low battery",
and continue to draw current - which the remaining cells are happy to
supply. Since all the cells are connected in series, this current flows
through the "empty" cell too, and actually starts charging it in reverse
polarity, with the "positive" terminal more negative than the case.
This will eventually destroy the weak cell. This is most likely to
happen when there are more cells in the pack (8 cells is worse than 4),
and when there is just one cell weaker than all the rest.

In the particular case you're asking about, you propose to add one
higher-capacity cell to 3 lower-capacity ones. That's less likely to
be a problem than with one lower-capacity, so you'll probably get away
with it. But given the low cost of 2 more new 2000 mAh to make up a
set of 4 all-new cells, why not do that?

I keep NiMH cells in "sets" of 4 when they are in good shape. But if
one fails, I use the remaining three in applications that need 1 or 2
cells, and use a new set of 4 for the devices that need 4.

Dave
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Is it OK to mix NiMH batteries? ray Digital Photography 1 August 20th 08 08:29 PM
RCR-V3 Batteries & AA NiMH Raoul Digital Photography 13 August 17th 07 12:33 PM
NiMH batteries with low self discharge Daniel Prince Digital Photography 11 April 6th 06 05:47 PM
Do NiMH batteries expire? [email protected] Digital Photography 126 April 18th 05 05:33 AM
CRV3s vs AA NiMH batteries Ken F. Digital Photography 28 June 27th 04 09:02 AM


All times are GMT +1. The time now is 11:03 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 PhotoBanter.com.
The comments are property of their posters.