Microtek 120TF Scanner - no support
On Sep 21, 12:52 pm, viewerofrecphoto wrote:
On Sep 18, 10:25 am, viewerofrecphoto wrote:
On Sep 18, 10:01 am, "Neil Gould" wrote:
Recently, viewerofrecphoto posted:
On Sep 18, 8:09 am, "Neil Gould" wrote:
Sorry to hear that the easy solution wasn't the fix.
If I follow what you've described, that it works soon after you turn
the unit on, but soon stops working, it sounds as if there is a bad
capacitor in the lamp's trigger voltage circuit.
There are 2 caps on the driver board - one connects to the lamp output
and the transformer. Its labeled "1S 3KV SEC:". The "S" might be an
"8"
This is a likely culprit. The key is the "...3KV...", or 3,000 volt
rating. All of the lamps had a trigger voltage higher than a couple
hundred volts, and it is typical that a capacitor such as this one would
feed a coil that connects to the lamp (you may be mistaking the coil for a
tranformer?). I'd replace this cap and see what happens.
The other cap is near the input, between ground and +12V and is
labeled
".47uf 50V"
I doubt that this cap would affect the problem at hand, but while you're
in there, replace it, too.
Neil
i just ordered from Mouser. will report back...
The new capacitor is in. So far, I've scanned a couple of slides and a
couple of
negatives and it seems to be working. This is using the new bulb and
the scans
look fine, with no recalibration other than what Lasersoft does
automatically.
I also replaced the noisy fan, so I'm very happy.
Thanks for your help!
Thank you for sharing this information,
I'm sure it will be useful to others!
|